14
Troubleshooting
No power.
No sound.
The unit does not start playback.
Radio stations cannot be tuned in.
Unable to record.
The remote control does not work
properly.
iPod does not work.
The power cord is not plugged in.
Check whether electricity failed.
Check whether you select right
function.
An unplayable disc is inserted.
The disc is dirty.
The antenna is positioned or
connected poorly.
Record protect tabs are removed.
The remote control is too far from the
unit.
There is an obstacle in the path of the
remote control and the unit.
The battery in the remote control is
exhausted.
Check whether the player is connected
to the unit correctly.
Plug in the power cord.
Check the condition by operating
other electronic devices.
Press FUNCTION and check the
selected function.
Insert a playable disc.
Clean the disc.
Connect the antenna securely.
Cover holes on back edge of tape
with tap.
Operate the remote control within
about 23 ft (7 m).
Remove the obstacle.
Replace the battery with new one.
Connect it to the unit correctly.
Symptom Cause Correction
General
CD
RADIO
TAPE
Remote control
ipod
POWER SAVE MODE
Press
11
/
]]
on
the player o
r
11
on the remote control
for
longer than 3 seconds as the device is powered on, you
can move into POWER SAVE MODE. Press again to
cancel.
Designs and specifications are subject to change without notice.
To Next Page
Loading...
Need help?
General
