19
OPERATION
ENGLISH
2
Reattach the cover by sliding it back into
position.
• When the wireless remote control display begins
to fade, replace the AAA (1.5 V) batteries.
• If the system is not going to be used for a long
time, remove the batteries to save their working
life.
• Do not use old and new batteries together.
Installing the Remote Control
Holder
1
Choose a suitable place where its safe and easy
to reach.
2
Fix the firmly to the wall with the supplied
screws.
3
Slide the remote controller inside the holder.
• The remote controller should never be exposed
to direct sunlight.
• The signal transmitter and receiver should
always be clean for proper communication. Use
a soft cloth to clean them.
• If other appliances are accidentally affected by
the remote controller, change their position or
consult your serviceman.
Setting the Current Time on the
Wireless Remote Control
1
Insert the batteries.
• The time flashes at the bottom of the display
screen.
2
Press the
e
or
f
button to set the current
time.
3
Press the
SET/CANCEL
button to stop the
flashing.
• The
On Timer
and
Off Timer
are available after
setting the current time.
• If you have already inserted the battery, reinsert
it or use the reset button to set the current time.
To Next Page
Loading...
