EasyManuals Logo
Home>LG>Remote Control>MultiSITE CRC1 Series

LG MultiSITE CRC1 Series Installation Manual

LG MultiSITE CRC1 Series
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
6
MultiSITE CRC 1 Controller
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG” is a registered trademark of LG Corp.
Note:
Clean up the site after all procedures are nished, and check that no metal
scraps, screws, or bits of wiring have been left inside or surrounding the
controller or indoor units.
Provide power to the outdoor unit compressor crankcase heaters at least
six (6) hours before operation begins.
Starting operation with a cold compressor sump(s) may result in severe bearing damage
to the compressor(s). Keep the power switch on during the operational season.
Do not block the indoor unit inlet or outlet.
Unit may malfunction.
Securely attach the electrical cover to the indoor unit. Non-secured covers
can result in re due to dust or water in the service panel.
Do not allow water, dirt, or animals to enter the unit.
There is risk of unit failure or degraded performance.
Do not spill water or other liquid on the inside of the indoor unit, espe-
cially on electrical components.
Do not drop the MultiSITE Controller
unit into water. If the unit is immersed in water or other liquid, contact your
local authorized LG distributor for support.
There is risk of unit failure or degraded performance.
Electronic controls are static sensitive devices.
Discharge yourself correctly before manipulating and installing the MultiSITE Controller.
This device must be installed to provide a separation distance of at least
8 inches from all persons and must not be located or operating in conjunc-
tion with any other antenna or transmitter.
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
A short circuit or wrong wiring may permanently damage Remote Control-
ler or equipment.
SAFETY INSTRUCTIONS

Other manuals for LG MultiSITE CRC1 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LG MultiSITE CRC1 Series and is the answer not in the manual?

LG MultiSITE CRC1 Series Specifications

General IconGeneral
BrandLG
ModelMultiSITE CRC1 Series
CategoryRemote Control
LanguageEnglish

Related product manuals