LG NB7530A - Pairing the Sound Bar System

Getting Started 11
Getting Started
1
Pairing the sound bar system
Setting up the sound bar system for
the first time
Connect every power cord of the sound bar system
to the outlet. The color LEDs on each of the sound
bar system start to blink and then they are paired
automatically. Refer to the table below.
When connection is completed, the yellow-green
LED on the subwoofer is turned on and the green
LED on the L channel sound bar is lit up for about 3
seconds.
y
If you operate main unit then wireless
subwoofer sound within a few seconds in
standby mode.
y
Set the distance between this unit and
wireless subwoofer within 10 m (32 ft.).
y
Optimum performance can be
implemented only when the unit and
the Wireless subwoofer within distance
of 2 m (6 ft.) to 10 m (32 ft.) is used since
communication failure may occur if longer
distance is used.
y
It takes a few seconds (and may take longer)
for the unit and subwoofer to communicate
with each other.
y
If there is a strong electromagnetic wave
product nearby, interference may occur. Put
the unit (wireless receiver, wireless speakers,
wireless subwoofer, and main unit) away
from there.
,
Note
When the sound bar system is not
paired automatically
When there is no sound from the R channel sound
bar or the wireless subwoofer, you have to pair the
sound bar system manually. You can check the
disconnected state by the color LED on each of the
sound bar system. Refer to the table below.
Before pairing manually, make sure that every
sound bar system is turned on.
1. Press the buttons (Yellow, 2, 5, 8, 0, Red) on
the TV's remote control toward the L channel
sound bar. The red LED on the L channel sound
bar starts to blink.
2. Press and hold PAIRING on the R channel
sound bar for about 5 seconds. The red and the
green LEDs start to blink alternately.
Pressing PAIRING on
the R channel sound bar,
you should use a shape
object such as a pen.
,
Note
3. Press and hold PAIRING on the wireless
subwoofer for about 5 seconds. The red and the
green LEDs start to blink alternately.
4. Unplug all the sound bar system.
5. After every LED on the sound bar system is
turned off, plug the sound bar system again.
You can listen to TV sound by the sound bar
system.
Information of the color LED indicators
State L channel R channel Wireless subwoofer
Standby
Red Red Red
Initial pairing Red (Blink) Green (Blink) Yellow-green (Blink)
Pairing Green (Blink) Green (Blink) Yellow-green (Blink)
Connected Green [ O Green [ O Yellow-green
Disconnected
O Green (Blink) [ Red Yellow-green (Blink) [ Red
NB7530A-N0_DTWNLLK_ENG.indd 11 2013-08-19  3:11:02