Getting Started 9
Getting Started
1
Precautions in using the touch buttons
y
Use the touch buttons with clean and dry
hands. - In a humid environment, wipe out
any moisture on the touch buttons before
using.
y
Do not press the touch buttons hard to
make it work. - If you apply too much
strength, it can damage the sensor of the
touch buttons.
y
Touch the button that you want to work in
order to operate the function correctly.
y
Be careful not to have any conductive
material such as metallic object on the
touch buttons. It can cause malfunctions.
>
Caution
Connecting the AC
Adapter
1. Connect the supplied AC power cord to the AC
adapter.
2. Connect the AC adapter cable to DC IN adapter
input.
3. Plug the AC power cord into an AC outlet. Then
the unit goes into standby mode.
Only use the AC adapter supplied with this
device. Do not use a power supply from
another device or manufacturer. Using any
other power cable or power supply may cause
damage to the device and void your warranty.
>
Caution
How to Attach the
Ferrite Core (For EMI
Only)
You must ax the cores (supplied with the model
you purchased) in order to reduce or eliminate
electrical interference.
1. Pull the stopper [a] of the ferrite core to open.
2. Wind the portable cable and USB cable on the
ferrite core.
3. Close the ferrite core until it clicks.
ND2530-BS.BGBRLLK_ENG_7550.indd 9 2013-03-26 3:27:52
To Next Page
Loading...
