23
Registering Magic Remote
Control
How to register the Magic
Remote Control
To use the Magic Remote, rst pair it with your
TV.
1 Put batteries into the Magic Remote and
turn the TV on.
2 Point the Magic Remote at your TV and press
the Wheel (OK) on the remote control.
* If the TV fails to register the Magic Remote,
try again after turning the TV off and back
on.
How to deregister the Magic
Remote Control
Press the / and (HOME) buttons
at the same time, for ve seconds, to unpair the
Magic Remote with your TV.
* Press and hold the / button for
more than 5 seconds to disconnect and re-
register the Magic Remote at the same time.
• It is recommended that an Access
Point (AP) be located more than
0.2 m away from the TV. If the AP is
installed closer than 0.2 m, the Magic
remote control may not perform
as expected due to frequency
interference.
• Do not mix new batteries with
old batteries. This may cause the
batteries to overheat and leak.
• Failure to match the correct polarities
of the battery may cause the battery
to burst or leak, resulting in re,
personal injury, or ambient pollution.
• This apparatus uses batteries. In
your community there might be
regulations that require you to
dispose of these batteries properly
due to environmental considerations.
Please contact your local authorities
for disposal or recycling information.
• Batteries inside or inside the product
shall not be exposed to excessive
heat such as sunshine, re or the like.
To Next Page
Loading...
