9
Mounting on the
Table
1 Lift and tilt the TV into its upright position
on a table.
• Leave a 10 cm (minimum) space from the
wall for proper ventilation.
10 cm
10 cm
10 cm
10 cm
10 cm
(Depending on model)
2 Connect the power cord to a wall outlet.
• Do not apply foreign substances (oils,
lubricants, etc.) to the screw parts
when assembling the product. (Doing
so may damage the product.)
• If you install the TV on a stand, you
need to take actions to prevent the
product from overturning. Otherwise,
the product may fall over, which may
cause injury.
• Do not use any unapproved items to
ensure the safety and product life
span.
• Any damage or injuries caused by
using unapproved items are not
covered by the warranty.
• Make sure that the screws are
inserted correctly and fastened
securely. (If they are not fastened
securely enough, the TV may tilt
forward after being installed.) Do not
use too much force and over tighten
the screws; otherwise screw may be
damaged and not tighten correctly.
• When installing on a cabinet or a
shelf using a stand, make sure its
width is greater than that of the TV.
To Next Page
Loading...
