Room Temperature Sensing select
Switch
1. Use Remocon's sensor
2. Use Indoor's sensor
3. Use senor which has lower temrerature
between Remocon's and indoor's
Zone State/Default E.S.P
1. Variable/Low E.S.P
2. Fixed/High E.S.P
3. Variable/High E.S.P
Mode select switch
1. Cooling only
2. Heater pump
Group control select switch
1. Case of Single control
2. Case of Group control
* When changing the product selection switch and group control switch, you must press the reset switch to use
the changed selection.
To Next Page
Loading...
Need help?
General
