1
Remove the sticker that is attached on back of insulation and
attach the remote control on the wall you want to install.
2
Separate the cover of remote control like the right hand side.
3
Fix the setup board on top of the insulation.
4
Install each remote control with the distance of at least 2cm
between them when installing several wired remote controls
horizontally.
Before installing the wired remote controller, set the switch on the back of the wired remote controller
to the required condition of the product.
Especially, if the switch exclusively for air conditioning and air conditioning/heating selection switch is
incorrectly set, it can cause a problem to the product operation.
To Next Page
Loading...
Need help?
General
