3. TECHNICAL BRIEF
- 31 -
3.3. Power management IC
3.3.1. General Description
SM-POWER is a highly integrated Power and Battery Management IC for mobile handsets. It has
been specially designed for usage with S-Gold2. Although optimized for usage with the Infineon S-
GOLD baseband device it is suitable for the S-GOLDlite and the E-GOLD+ baseband devices as
well. It also supports the cellular RF devices like SMARTi-DC, SMARTi-DC+, SMARTi-SD and the
Bluemoon Single, Infineon’s single chip solution for Bluetooth. If used with S-GOLD2 it provides all
power supply functions (except for the RF PA) for a complete advanced GSM Edge smart phone
minimizing external device count.
Block Description
• Highly efficient step-down converter for main digital baseband supply including Core, DSP and
memory interface (External Bus Unit).
• Support of S-GOLD standby power-down concept
• Low-drop-out (LDO) regulators for Flash and mobile RAM memory devices
• Voltage independent switching of two SIM cards
• LDO regulators for baseband I/O supply
• LDO regulator for analog mixed-signal section of S-GOLD
• Low-noise LDO regulators for RF devices
• Supply for Bluemoon Single, Infineon’s single chip solution for Bluetooth
• Audio amplifier 8 Ohms for handsfree operation and ringing
• Charge Control for charging Li-Ion/Polymer batteries under software control
• Pre-charge current generator with selectable current level
• RTC regulator with ultra-low quiescent current
• USB interface support for peripheral and mini-host mode
• Backlight LEDs driver with current selection and PWM dimming function
F32K to 32k crystal
OSC32K to 32k crystal
RESET_n RESETn
CC1CC1IO TRIG_OUT For JTAG & ETM Interface
RTC_OUT RTC_OUT
VCXO_EN XO_ENE
CLKOUT0 26M_DAC For Audio AMP
GPIO_62 BT_RST For Bluetooth
GPIO_63 SIM_EN_n
To Next Page
Loading...
