Installation Manual 23
ENGLISH
Thermistors Installation
Fixation of the pipe thermistors (Field work)
1. Fix the thermistor with insulating aluminum tape (Field supply) in order to ensure a good
heat transference.
2. Put the supplied piece of rubber around the thermistor(EBG36949304/05) in order to
avoid loosening of the thermistor after some years.
3. Fasten the thermistor with 2 tie wraps.
4. Insulate the thermistor with the supplied insulation sheet.
INSTRUCTION
■ Put the thermistor wire slightly top to avoid water accumulation on down of the thermistor.
■ Make good between thermistor and evaporator. Put the top of the thermistors on the
evaporator, this is the most sensitive point of the thermistor.
1 Most sensitive point of the thermistor
2 Maximize the contact
To Next Page
Loading...
