LG ProCentric 55UV560H - Page 56

56
206-4326
IP Environment Setup (Cont.)
(Continued from previous page)
2. With the Network Menu on display, use the arrow keys on the
Installer Remote to select Network Setting. Then, press OK. A
second Network screen (see example at right) will be displayed.
By default, the TV uses DHCP, and if a LAN cable is detected,
the TV will attempt to connect to the network as soon as you
select “Network Setting” above. If the TV is able to connect to
the network, a “Connected to Internet” message will be displayed
below the Wired Connection eld.
3. If the network is not congured for DHCP or you want to specify
static conguration data or you would like to change the network
conguration from Manual to Automatic, edit the IP conguration
for this TV as follows:
• In the second Network screen, select Wired Connection and
press OK. Then, in the Wired screen, select Edit (if not already
selected) and press OK.
• In the Edit IP screen, select or de-select the “Set Automatically”
checkbox, as required. A checkmark indicates that Automatic
conguration is enabled.
• To manually edit the IP conguration, for each data entry
eld: Use the arrow keys on the Installer Remote to select
the eld and press OK. You can use the number keys on the
Installer Remote to direct enter numeric values or use the
arrow keys to select the appropriate numbers from the pop-up
virtual keyboard displayed at the bottom of the screen. (Note,
however, that you must use the dot “.” key from the virtual
keyboard to separate each octet of an IP address.) When you
are done, select Enter from the virtual keyboard, and then
press OK on the Installer Remote.
• When all Edit IP elds are set as required, use the arrow keys
on the Installer Remote to select Connect and press OK.
At the top of the screen, you will see a progress display that
indicates status as each network element is conrmed (see
example at right).
If the network is connected successfully, a “Connected to Internet”
message will appear just below the progress display. If the
network connection is not successful, the progress display will
identify the network element in which the connection failed. Check
your cabling and/or verify the conguration data, as necessary.
4. Once the wired network conguration is complete, use the arrow
keys on the Installer Remote to return to the IP Environment
Menu, as necessary, or press
to return to the previous Network
Menu level(s) and/or exit the IP Environment Menu.
NETWORK SETT...
Network /
Wired Connection (Ethernet)
Not Connected
Network
Pro:Centric
EDIT IP
Network / Network Setting / Wired Connection (...
Connected to Internet
Set Automatically
IP Address
Subnet Mask
Gateway
DNS Server
CONNECT
Network
Pro:Centric
WIRED
Network / Network Setting /
Connected to Internet
IP (Automatic)
IP Address 10.1.2.4
Subnet Mask 255.255.255.0
Gateway 10.1.2.3
DNS Server 10.1.2.3
MAC Address C8:08:E9:40:49:F5
EDIT
Network
Pro:Centric
DNS
10.1.2.4
DNS
10.1.2.3
10.1.2.3
255.255.255.0