7
206-4326
Commercial Mode Overview (Cont.)
Installer Menu
To create a Master TV Setup, you will need to know how to access
the commercial controller (PTC) Installer Menu and make changes to
the default values as required. If necessary, familiarize yourself with
the Installer Menu and how to make and save changes. See pages 30
to 39 for information on accessing the Installer Menu and for detailed
descriptions of the Installer Menu items.
TV Setup Menus
On-screen setup menus control the features of the TV. Use the
Installer Remote to access the TV setup menus, and set the TV
features to the desired configuration for the end user.
Cloning
Cloning refers to the process of using a Master TV Setup to configure
a Target TV. The Master TV’s clonable setup menu features should
be configured as part of the Master TV Setup. If there are features in
the Master TV’s setup—channel icons or labels, digital font options,
etc.—that are not set or that are set incorrectly, those features also
will not be set or will be set incorrectly in the Target TVs. See pages
43 to 48 for detailed information on Clone (.tlx) les and cloning
requirements and procedures.
External MPI or TLM Control
To control the TV using an external MPI control device, you must use
the TV’s MPI port for communication purposes.
To control the TV using an external TLM control device, you must use
the TV’s RS-232C port for communication purposes. See Reference
section, “TLM Communication Parameters,” for further information.
FTG Mode
In this mode, the TV’s CPU is congured with an FTG Channel Map,
and the CPU controls and restricts the tuning operation of the TV
based on this FTG Channel Map. The FTG Channel Map enables the
decryption of each Pro:Idiom
®
encrypted channel and also provides
logical channel mapping of physical RF channels (digital and analog)
and Aux inputs. In addition, in these models, FTG Mode provides the
option to select either logical or physical tuning (see notes below)
during configuration.
Note: Logical channel mapping of physical RF channels eliminates
dash tuning; for example, physical 19-3 can be mapped to logical
channel 9. It also allows physical RF channels and Aux inputs to
be listed in any order, not only in physical numeric ascending order.
Physical channel tuning requires that you include the dash when
direct entering RF channel numbers and Aux inputs (the latter
designated by 130-0 through 137-0).
PTC INSTALLER MENU
xxUV560H
CPU - CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 SW 5331 7F60
PTC V#.##.### CPU V#.##.##.##
Typical Installer Menu
TV Setup Menus (Advanced Settings)
TV Setup Menus (Quick Settings)
X
Picture
Sound
Channels
General
Safety
Accessibility
PICTURE
Smart Picture Mode
Picture Mode Settings
Aspect Ratio Settings
16:9
To Next Page
Loading...
