82
206-4326
Reference: TLM Communication Parameters (Cont.)
17. Channel Add/Delete (NTSC) (Command: m b)
To set the saved channel status to delete or add.
Transmission
[m][b][ ][Set ID][ ][Data][Cr]
Data 00: Delete
01: Add
Ack
[b][ ][Set ID][ ][OK/NG][Data][x]
18. Key (Command: m c)
To send IR remote key code.
Transmission
[m][c][ ][Set ID][ ][Data][Cr]
Data Key code. See Key Codes table on page 83.
Ack
[c][ ][Set ID][ ][OK/NG][Data][x]
19. Control Backlight (Command: m g)
To control the backlight.
Transmission
[m][g][ ][Set ID][ ][Data][Cr]
Data Min: 00 to Max: 64
Ack
[g][ ][Set ID][ ][OK/NG][Data][x]
20. Input select (Command: x b)
To select input source for main picture. *
Transmission
[x][b][ ][Set ID][ ][Data][Cr]
Data 00: DTV 01: CADTV
02: Satellite DTV 10: ATV
11: CATV
20: AV or AV 1 21: AV 2
40: Component 1 41: Component 2
60: RGB
90: HDMI 1 91: HDMI 2
92: HDMI 3 93: HDMI 4
Ack
[b][ ][Set ID][ ][OK/NG][Data][x]
* This function depends on model and signal.
To Next Page
Loading...
