38
Timer Recording with
G-
CODE
®
System
This system makes programming timer recordings
very simple. Most TV guides publish G-
CODE
programming numbers with their program details.If
you want to make a timer recording of a program, you
just input the corresponding G-CODE programming
number. The date, start, stop and channel settings are
made automatically. All you have to do is tell the
recorder the recording mode, and whether it’s a once-
only recording, or a regular recording.
Up to 16 timer programs can be stored in the
recorder.
G-
CODE is a registered trademarks of Gemstar
Development Corporation.
The G-CODE System is manufactured under license
from Gemstar Development Corporation.
1. Press G-
CODE button or select [G-CODE] option in
the [HOME] menu.
The G-
CODE menu will appear.
Press RETURN (O) to exit the menu.
[Number] Enter the G-CODE
programming
number.
2. Use the number buttons then press ENTER to
enter the G-
CODE
programming number.
To check the programming, the Timer Record
menu will appear.
If you make a mistake before pressing ENTER,
press CLEAR repeatedly to delete numbers one
by one then correct it.
3. You can change the information as required using
b / B / v / V (PR etc.)
Refer to “Timer Recording” on previous page.
4. Choose a record mode (XP, SP, LP, EP or MLP).
5. Press ENTER, the program will be memorized by
the recorder.
To check the programming, the Timer Record List
will appear.
Check field’s “Rec. OK” on the Timer Record List
indicates that the timer recording is programmed
correctly.
6. Press RETURN (O) to exit the Timer Record
menu.
7. Make sure that you press POWER to switch your
unit to Standby.
HDD
To Next Page
Loading...
Need help?
General
