LG SJ9 - Remote Control; Additional Information

Remote control
Replacement of battery
SOUND EFFECT: Selects a sound effect mode.
F: Selects the function and the input source.
8: Turns down the volume at night.
: Adjusts sound level of Treble, Bass and Sub-woofer.
INFO: Displays the input source information.
AV SYNC: Synchronizes the audio and video.
SLEEP: Setsthesystemtoturnoffautomaticallyataspecied
time.
AUTO VOL:
Adjusts too loud or low output volume level
appropriately.
AUTO POWER: Automatically turns on by an input source.
Additional Information
Specication
Power
requirement
Refer to the main label.
Power
consumption
Refer to the main label.
Networked standby : 6.5
W
(If all network ports are activated.)
Dimensions
(W x H x D)
Approx. 1200 mm x 58 mm x 145 mm
Amplier
(Total RMS
Output power)
500 W RMS
Designandspecicationsaresubjecttochangewithoutnotice.
OPEN SOURCE SOFTWARE NOTICE
INFORMATION
To obtain the source code under GPL, LGPL, MPL, and other open
source licenses, that is contained in this product, please visit
http://opensource.lge.com.
In addition to the source code, all referred license terms, warranty
disclaimers and copyright notices are available for download.
LG Electronics will also provide open source code to you on CD-
ROM for a charge covering the cost of performing such distribution
(such as the cost of media, shipping and handling) upon email
request to opensource@lge.com. This offer is valid for three (3)
years from the date on which you purchased the product.
How to disconnect the wireless network
connection or the wireless device
Press and hold the “ (Add)” button until you hear the beep
sound twice.
POWER: This unit operates on a mains supply of
200 - 240 V ~ 50 - 60 Hz.
Wiring: This unit is supplied with a BS 1363 approved main plug.
When replacing the fuse, always use of the same rating approved
to BS 1362. Never use this plug with the fuse cover omitted. To
obtain a replacement fuse cover contact your dealer. If the type of
plug supplied is not suitable for the mains sockets in your home,
thentheplugshouldberemovedandasuitabletypetted.Please
refer to the wiring instructions below:
Warning: A mains plug removed from the mains lead of this unit
must be destroyed. A mains plug with bared wires is hazardous
if inserted in a mains socket. Do not connect either wire to the
earth pin, marked with the letter E or with the earth symbol
6
or
colouredgreenorgreenandyellow.Ifanyotherplugistted,use
same rating of fuse in the plug.
Important: The wires in this mains lead are coloured in accordance
with the following codes:
- BLUE: NEUTRAL, BROWN: LIVE - As the colours of the wires in
the mains lead of this unit may not correspond with the coloured
marking identifying the terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black. The wire which
is coloured brown must be connected to the terminal which is
marked with the letter L or coloured red.