To Next PageTo Next Page
Need help?Do you have a question about the LG StudioWorks 710S and is the answer not in the manual?
General| Screen Size | 17 inches |
|---|---|
| Viewable Image Size | 16.0 inches |
| Maximum Resolution | 1280 x 1024 |
| Refresh Rate | 75 Hz |
| Aspect Ratio | 4:3 |
| Panel Type | CRT |
| Horizontal Scan Rate | 30 - 70 kHz |
| Vertical Scan Rate | 50 - 160 Hz |
| Bandwidth | 110 MHz |
| Input Signal | Analog RGB |
| Input Connectors | 15-pin D-sub |
| Power Consumption | 85W (typical) |
| Weight | 16 kg |
The only potential source of X-radiation is the picture tube. Basic precaution is to keep high voltage at factory level.
Procedure to check and verify B+ voltage using a cross hatch pattern at Mode 4.
Procedure to adjust high voltage to 25.8kV±0.1 kVdc using specific alignment commands.
Diagnostic flow for issues where the monitor has no power, checking fuse, voltage, and ICs.
Diagnostic flow for missing display characters, checking IC302, IC303 signals, and CRT socket.
Diagnostic flow for missing raster, checking power indicator, G1 voltage, and CDT heat voltage.
Diagnostic flow for no horizontal picture, checking Q706, B+ voltage, FBT, and Q705 waveform.
Diagnostic flow for unbalanced horizontal linearity, checking IC401, Q711-Q716, and L703.
Diagnostic flow for no vertical picture, checking IC601, IC701 signals and voltages.
Diagnostic flow for OSD issues, checking IC302 voltage and waveform, and peripheral circuits.
Diagnostic flow for Display Power Management (DPM) failures, checking IC401 signals and DPM table.
Diagnostic flow for degaussing failure, checking IC401, Q953, P902, and RL901.
Diagnostic flow for tilt/rotation issues, checking IC401, voltage lines, and Q503 emitter.
