77
12-9. Vibration
Is the product on the floor level?
Are you operating the product after
hanging an empty hanger?
Explain the solution to the customer.
Adjust the height of the product leg to make the product
level.
Install the
product on
the rm, at
surface.
• Be sure to install the product on the rm, at surface.
A weak, hollow stand Slanted oor Uneven oor
Leveling
• Use the spanner that is provided with the
product to adjust the height of the legs.
( Rotate the spanner clockwise to raise the
height of the product and rotate it counter-
clockwise to lower the height.)
After adjusting the legs, rotate the tightening
nut fully to the right.
• If the product moves when you press its front/left/
right corner or shake it or
when it is spin drying,
readjust the leveling legs.
NO
YES
To Next Page
