LG Styler S3RERB - Page 80

80
Are the main PCB connector (BL12) and thermistor connector (BL2) at the top of
the evaporator properly assembled?
Is the EVAPORATOR_THERMISTOR properly assembled?
(deviation, etc.)
Replace the thermistor.
Are the thermistor connector (BL2) and main PCB connector (BL12) properly
connected?
Do you feel the vibration of comp 1 minute after starting the Drying cycle?
Replace the thermistor.
Connect the connector.
Assemble the thermistor.
(Insert it to the pipe.)
Connect the connector.
Replace comp and perform repair.
NO
NO
NO
NO
YES
YES
YES
YES
12-12. TE3
12-13. TE5