LG SXS - Handle; Shroud, Grille Fan; Icemaker Assembly; Aluminum Short Handle Model

2. HANDLE
1) Aluminum short handle Model
(1) Grasp the handle by both hands and hold it upward.
3. SHROUD, GRILLE FAN
1) Loosen screws after disconnecting a cap screw of a grill
fan(U) with a blade screwdriver.
2) Disassembly of a grille fan(U) : Pull forward after
opening hook at
part with a blade screwdriver.
3) Disconnect housing and disassembly of shroud F(U)
: holding upper part and pull forward
4) Disassembly of a grille fan(L) : Hold upper part of a grill
fan(L) and pull forward carefully
5) Check foam PU sticking conditions around a shroud,
F(U) and F(L) during assembling. If damaged, torn or
badly sticked, assemble with a new one after sealing
well.
4. ICEMAKER ASSEMBLY
1. How to disassemble :
(1) Remove the cover and ice bucket from the freezer door.
(2) Disassemble the Motor, AC and icemaker
• Caution : When pulling out the Motor AC, do not damage
the water injector.
(3) Disconnect housing and loose screws
HOW TO DISASSEMBLE AND ASSEMBLE
- 115 -
Loosen four
screws.
Lift up the Motor,
AC assembly
Pull out the Motor,
AC with swing like
this figure.
Disconnect the
housing
Loosen screw of
guide water
Loosen screws of
icemaker and pull
out the icemaker.