7. DISPENSER
1) Disconnect funnel assembly by pulling down and
forward.
2) Disconnect the cover by pulling it fully to the front
and
pull up the rear end of the cover
slightly to pull it out
.
3) Remove a dispenser cover assembly by pulling a low
side. It is attached with a hook so be pulled carefully
4) Remove a dispenser cover assembly by pulling a right
and left side. It is attached with a hook so be pulled
carefully. After sepsrating a dispenser cover, you have
to disconnect its housing
5) Loosen fixed screws with a screwdriver and pull the
funnel assembly to disconnect.
You can change LED Lamp in this disassemble state
6) The duct cap assembly can be disconnected if the hold
lever connecting screw is loosened with a screwdriver.
7) To install the duct cap assembly, insert one end of the
spring into the right hole of the dispenser lever and
insert the other end into the right hole in the top part of
the dispenser. Then attach the holder at the solenoid
switch.
To Next Page
Loading...
