10
INSTALLATION
Installation Place
Requirements
Before installing the appliance, check the following
information in order to install the appliance in a
correct place.
Unpacking Shipping Material
1
Lift the appliance off of the foam base.
• After removing the carton and shipping
material, lift the appliance off the foam base.
• Make sure the plastic tub support
a
comes
off with the base and is not stuck to the
bottom of the appliance.
• If you must lay the appliance down to
remove the carton base
b
, always protect
the side of the appliance and lay it carefully
on its side. Do not lay the appliance on its
front or back.
2
Remove the foam tub insert.
• To prevent damage, do not remove the foam
insert
c
from the tub until the appliance is in
the final location.
• Once removed, save the foam insert for future
use. If the appliance needs to be moved, the
foam insert will help prevent damage during
transportation.
3
Unfasten the power cord.
• Unfasten the power cord from the back of
the appliance.
Installation Location
• Install the appliance on a flat floor of hard
material that is strong enough to support a fully
loaded appliance. (Allowable slope under the
appliance: 1º)
• Never try to level any uneven floor by putting
pieces of wood, cardboard or similar materials
under the appliance.
To Next Page
Loading...
Need help?
General
