What does UNBALANCE ERROR mean on my LG T2310VSPM Washer?
The UNBALANCE ERROR on your LG Washer means the automatic rebalancing of the laundry load was unsuccessful, pausing the cycle. Manually adjust the laundry inside the washer.
How to fix the dE DOOR ERROR on my LG T2310VSPM?
The dE DOOR ERROR on your LG Washer typically means the door isn't closed properly or was opened during operation. Ensure the door is completely closed. If the error persists, call for service. If the door was opened mid-cycle, press Start/Pause to cancel the error, then press Start/Pause again to resume the wash programme.
What to do if my LG T2310VSPM shows a 1E INLET ERROR?
A 1E INLET ERROR on your LG Washer indicates a water supply issue. Here's what to check: 1. Make sure the water supply taps are fully open. 2. Inspect the water supply hoses for kinks, pinches, or crushing; straighten or reinstall them if needed. 3. Check and clean the filters of the supply hoses. 4. Contact a plumber to check the water pressure if it seems too low or too high. 5. Do not use leak limiting hoses.
Why does my LG Washer show an OE WATER OUTLET ERROR?
The OE WATER OUTLET ERROR on your LG Washer usually indicates a problem with the drain hose. Check if the drain hose is kinked, pinched, or clogged, and clean and straighten it. Also, ensure the drain discharge point is not more than 1.2 m above the bottom of the appliance; adjust the hose or drain pipe if necessary.
To Next Page
General
