LG T2511VSA - Installing the Drain Hose

14
EN
Connecting Hose to Appliance
Attach the hot water line to the hot water inlet on
the back of the washing machine. Attach the cold
water line to the cold water inlet on the back of the
washing machine.
NOTE
• After completing connection, if water leaks from
the hose, repeat the same steps. Use the most
conventional type of tap for the water supply.
In case the tap is square or too big, remove
the guide plate before inserting the tap into the
adaptor.
Installing the Drain Hose
Before connecting the drain hose, check your drain
hose model and choose the correct instruction.
Pump Model
• The drain hose should not be placed higher
than 120 cm above the floor. Water in the
washing machine may not drain or may drain
slowly.
• Securing the drain hose correctly will protect
the floor from damage due to water leakage.
• If the drain hose is too long, do not force it
back into the washing machine. This will cause
abnormal noise.
• When installing the drain hose to a sink, secure
it tightly with string.
0.9 - 1.2 m
0.9 - 1.2 m
Laundry tubLaundry tub
Hose Hose
retainerretainer
Tie strapTie strap
NOTE
• The discharge height should be approximately
0.9 - 1.2 m from the floor.