38
EN
Symptoms Reason Solution
Control error.
• Unplug the washing machine and wait 60
seconds. Reconnect power and try again. If the
error code is not released, call for service.
Water level is too high due to
a faulty water valve.
• Close the water taps, unplug the washing
machine, and call for service.
The water level sensor is not
working correctly.
• Close the water taps, unplug the washing
machine, and call for service.
A motor error has occurred.
• Allow the washing machine to stand for 30
minutes and then restart the cycle. If the error
code is not released, call for service.
Clutch error.
• Unplug the washing machine and call for
service.
Tub Clean Alarm. • Run the Tub Clean programme.
Sensor for cloth-sensing is
defective.
• Manually redistribute the load if articles have
become tangled.
Motor’s revolution is too low.
• Unplug the washing machine and wait 60
seconds. Reconnect power and try again.
• Call for service.
Contact-point of Connector is
defective.
CL is not an error. This
prevents children from
changing cycles or operating
the appliance.
• To deactivate, press and hold the Beeper and
Rinse buttons simultaneously for 3 seconds.
To Next Page
Loading...
