LG Therma V AHBW Series - Page 28

- 28 -
krameRliateDmetIedoC
edom gnilooc ni erutarepmet ffo-tuc gnitteSnoitcnuF22
(FCU setting included)
Description Determine leaving water temperature when the unit is turned off.
This function is used for preventing condensation
on the floor in cooling mode.
Value #1 Note Cut-off temperature. Value #1 is valid when Value #2 is
'01 (that means, FCU is installed)'."
C° 61tluafeD
C° 52 ~ 61egnaR
Value #2 Note Determines if FCU is installed or not. '01' means 'FCU is
not installed', and '00' means 'FCU is installed.'
00tluafeD
Range 00(Equipped) ~ 01(not Equipped)
23 Function Setting outdoor temperature range for weather-dependent
operation
Description Setting outdoor Max/Min temperature for weather-dependent
operation
egnar gnittes fo timiL reppUetoN1# eulaV
C° 01-tluafeD
C° 50 ~ 02-egnaR
egnar gnittes fo timiL rewoLetoN2# eulaV
C° 51tluafeD
C° 02 ~ 01egnaR
24 Function Setting indoor air temperature range for weather-dependent
operation
Description Setting indoor Max/Min temperature for weather-dependent
operation
egnar gnittes fo timil reppUetoN1# eulaV
C° 12tluafeD
C° 03 ~ 02egnaR
egnar gnittes fo timil rewoLetoN2# eulaV
C° 61tluafeD
C° 91 ~ 61egnaR
erutarepmet ffo / no retaeh cirtcele gnitteSnoitcnuF12
ffO = 6.oNffO = 6.oNhctiws PID
ffO = 7.oNnO = 7.
oNgnittes
Description Setting for using Step 1 capacity
of electric heater
Setting for using Step 2 capacity
of electric heater
Value #1 Note
Base outdoor air temperature
C° 0tluafeD
C° 81 ~ 51-egnaR
Value #2 Note Not used
C° 0-tluafeD
C° 33 ~ 0-egnaR
DIP Switch
setting is
described in
Chapter 6 of
Installation
Manual.
Outdoor air temperature where
Step 1 capacity of electric heater
starts operation.
Temperature gap (it means 'how
much colder than base outdoor
air temperature?')