LG V9WD96H2 - User Manual

Questions and Answers

A
Alexis WillisAug 11, 2025
What to do if my LG V9WD96H2 Washer/Dryer shows an OE WATER OUTLET ERROR?
- W
  William HayesAug 11, 2025
  The OE WATER OUTLET ERROR on your LG Washer/Dryer usually indicates a problem with the drain hose or drain filter. This error appears when the drain hose is either kinked or clogged, or if the drain filter is clogged. To fix this, begin by cleaning and straightening the drain hose. Also, check and clean the drain filter.
J
Jimmy ColeAug 20, 2025
Why does my LG Washer/Dryer show a UE UNBALANCE ERROR?
- V
  vcowanAug 20, 2025
  The UE UNBALANCE ERROR on your LG Washer/Dryer typically occurs because the laundry load is unbalanced. This can happen if the load is too wet at the end of the cycle or if the load is too small. To resolve this, rearrange the laundry to allow proper spinning. If the load is too small, add one or two similar items to help balance it. Then, close the door and press the Start/Pause button. Please note that it may take a few moments before the appliance begins to spin, and the door must be locked before spin can be achieved.
D
Dylan FletcherAug 31, 2025
How to fix a 1E INLET ERROR on my LG V9WD96H2?
- M
  michealburnsSep 1, 2025
  The 1E INLET ERROR on your LG Washer/Dryer indicates an issue with the water supply. This could be due to inadequate water supply, a water supply tap not being fully open, kinked water supply hoses, or clogged supply hose filters. First, check another tap in the house to ensure adequate water supply. Then, fully open the water supply tap. Next, straighten any kinked water supply hoses or reinstall the water inlet hose. Finally, check and clean the filter of the inlet hose. If water leakage occurs in the aqua stop supply hose, and the indicator becomes red, replace the aqua stop supply hose.