LG WD-11270BD User Manual (English)

Questions and Answers:

J
Jason BradleyAug 28, 2025
What does LOCKED MOTOR ERROR mean on my LG WD-11270BD?
- A
  Alisha LopezAug 28, 2025
  A LOCKED MOTOR ERROR can occur for several reasons: the connector (3-pin, male, white) in the MOTOR HARNESS is not connected to the connector (3-pin, female, white) of STATOR ASSEMBLY; the electric contact between the connectors (3-pin, male, white) in the MOTOR HARNESS and 4-pin, female, white connector in the MAIN PWB ASSEMBLY is bad or unstable; the MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY is cut (open circuited); or the hall sensor is out of order/defective.
H
Hailey SanchezAug 27, 2025
What to do if my LG WD-11270BD Washer is leaking?
- M
  Meredith MatthewsAug 28, 2025
  If you're experiencing water leaks with your LG Washer, or if water isn't entering or draining properly, check the fill hose connections at the tap and washer and tighten them if loose. Ensure your house drain pipes are not clogged, and contact a plumber if needed. Reduce the amount of detergent you're using, or switch to a low-sudsing detergent if you notice excessive suds. Confirm that your water supply is adequate by checking another tap in the house and fully opening the water supply tap. Straighten any bent water inlet hoses and check the filter of the inlet hose. Finally, inspect the drain hose for any bends or clogs, and clean the drain filter if it's clogged.
J
John OwenAug 27, 2025
Why my LG Washer does not start?
- C
  Candace WatsonAug 27, 2025
  If your LG Washer doesn't start or won't spin, ensure the power cord is securely plugged into the wall outlet. Check your house fuse or circuit breaker, and reset it if necessary. Make sure the water supply tap is turned on. Also, verify that the door is firmly shut; press the Start/Pause button, keeping in mind that it may take a few moments for the washer to begin spinning after the door locks.
M
Matthew Miles Jr.Aug 26, 2025
What to do if my LG WD-11270BD is leaking water?
- J
  Jessica JonesAug 27, 2025
  If you notice water leaks from your LG washer, here are some potential causes and solutions: * Check if the fill hose connection is loose at the tap or washer and tighten it. * Ensure that house drain pipes are not clogged. Unclog the drain pipe or contact a plumber if necessary. * Too much or unsuitable detergent can cause leaks. Reduce the amount of detergent or switch to a low-sudsing detergent. * Verify that the water supply is adequate in your area by checking another tap in the house. * Make sure the water supply tap is fully open. * Inspect the water inlet hose for any bends and straighten it. * Check the filter of the inlet hose for clogs. * Examine the drain hose for bends or clogs and clean and straighten it. * Clean the drain filter if it is clogged.
T
tcantrellAug 25, 2025
Why won't my LG WD-11270BD start?
- W
  Whitney PooleAug 26, 2025
  The LG washer might not start due to several reasons: * The power cord may not be properly plugged in. Ensure the plug fits tightly into the wall outlet. * A blown fuse or tripped circuit breaker could be the issue. Reset the circuit breaker or replace the fuse. Do not increase fuse capacity. If it's a circuit overload, consult a qualified electrician. * The water supply tap might not be turned on. Make sure to turn it on. * The door might not be firmly shut. Close the door properly and press the Start/Pause button. Note that it may take a few moments for the washer to begin spinning after pressing the button, as the door must lock first.
F
fred05Aug 25, 2025
What does it mean if my LG Washer shows a LOCKED MOTOR ERROR?
- S
  Susan MartinezAug 25, 2025
  A LOCKED MOTOR ERROR in your LG Washer can be caused by several issues: 1. The MOTOR HARNESS connector is not connected to the STATOR ASSEMBLY connector. 2. Bad or unstable electrical contact between connectors in the MOTOR HARNESS and the MAIN PWB ASSEMBLY. 3. The MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY is cut. 4. The hall sensor is defective.