LG WD-1370 Series User Manual

21
aintenance
M
" The water inlet filter
- " " error message will blink on the control panel when water does not enter the
detergent drawer.
- If your water is very hard or contains traces of lime deposit, the water inlet filter may
become clogged.
It is therefore a good idea to clean it from time to time.
" The drain pump filter
❋ The drain filter collects threads and small objects left in the laundry.
Check regularly that the filter is clean to ensure smooth running of your machine.
CAUTION First drain it using the drain hose and then open the pump filter to remove
whatever may have stopped it up.
Be careful when draining if the water is hot.
❋ Before cleaning the washer interior, unplug the electrical power cord to avoid electrical
shock to avoid electrical shock hazards.
3
2
3
2
1
100
1. Turn off the
water tap.
2. Unscrew the
water inlet
hose.
3. Clean the
filter using a
hard bristle
brush.
4. Tighten up
the inlet
hose.
!
1. Open the lower cover
cap (
) by using
coin. Turn the drain
plug (
) to pull out
the hose.
2. Unplug the drain plug ( ),
allowing the water to flow out. At
this time use a vessel to prevent
water flowing on to the floor. If the
water does not flow any more, turn
the pump filter (
) open to the left.
3. Take out any foreign material
from the pump filter (
). After
cleaning, turn the pump filter (
)
clockwise and insert the drain
plug (
)to the original place.
close the lower cover cap.

LG WD-1370 Series Specifications

General

Brand	LG
Model	WD-1370 Series
Category	Washer
Language	English