LG WD-14120(5)RD - Page 25

24
Rinse
Spin
Wash
Rinse
NO
YES
YES
YES
NO
YES
YES
NO
NO
NO
YES
(1)
(1)
(2)
Door Lock
SPIN TROUBLE
DOOR DOES NOT OPEN
Check the S.PRESSURE SWITCH
ASSEMBLY or HOSE (Pressure).
If the problem is on the
S.PRESSURE SWITCH
ASSEMBLY or the HOSE,
replace the S.PRESSURE
SWITCH ASSEMBLY or the
HOSE.
Normal
Correct the connector.
Replace the STATOR
ASSEMBLY
Check on the spinning, is the frequency of the
water level 248 or more. The frequency can be
checked by pressing the Wash and Rinse buttons at
the same time on the program.
When pressing Rinse, Spin and POWER buttons at
the same time after power off, press the Start/Pause
button 1 times, is the drum low speed spin?
Is it disconnected, or disassembled?
[Red:3pin(1), NA:4pin(2)]
Check the motor connector, is the resistance of
the terminal same as the figure?
MOTOR TERMINAL (1)
Resistance of terminal:





About 5

15

Replace the MAIN PWB ASSEMBLY
Is
^^
Door lock
__
Display lamp on?
After draining and
^Door lock_lamp off,
open the door.
Check switch Assembly,
Door lock connector and
Main PWB
ASSEMBLY(Blue, 3pin)
Is
^^ __
Displayed?
  