7-1.BEFORE SVC CHECKING
¡ÆBe careful of electric shock while trouble shooting.
¡ÆDisconnect power plug from the outlet before service.
7-2.TEST MODE.
¡ÆIf you press ¡aPower¡bbutton with both ¡aRinse¡band ¡aSpin¡bbuttons pressed the machine can be gotten into the test
mode.
¡ÆTo check if functions operate well, press ¡aStart/Pause¡bbutton in test mode as follows.
7-3.HOW TO KNOW THE WATER LEVEL FREQUENCY
ƒRPress the
£ Wash£and £ Rinse£buttons simultaneously.
ex) 641 : Water level frequency = 241¡¿10
-1
§
(¡fi2¡flis ommitted)
Water is added.
13
7. TROUBLE SHOOTING
The last two digits means water level frequency(10
-1
§
)
If water is added in operation, number Ô6Õ will appear.
Times of press
Checking Point Display Status
None All lamps turn on
1 time Counterclockwise spin 3~6 (Drum rpm ¡ 10)
2 times Low speed Spin 55~65 (Drum rpm ¡ 10)
3 times High speed Spin 95~105 (Drum rpm ¡ 10)
4 times Inlet valve for pre-wash operation Water level frequency(25~65)
5 times Inlet valve for main-wash operation Water level frequency(25~65)
6 times Inlet valve for main-wash operation Water level frequency(25~65)
7 times Clockwise spin 3~6 (Drum rpm¡ 10)
8 times
The Heater is in operation for 3 sec.
Water Temperature
9 times Draining pump operation Water level frequency
10 times
Auto off operation
NOTE : Even if you press the button to check inlet valve, inlet valve does not operate until the drum
comes to a complete stop from spinning.
To Next Page
Loading...