28
¤ Remove the back cover.
¤ŁTake off the belt turning the pulley.
¤ØUnscrew the bolt to pull out the pulley.
¤ Unscrew 2 screws from the bracket.
¤ŁPush the motor in the arrow direction for
disassembling.
¤ØWhen reassembling the motor, make sure that motor
mounting rubbers are not taken off from the bracket.
¤ Pull out the hinge pressing its snap.
¤ŁDo not use the pulled out hinge again..it may be taken
off during operation.
PULLEY, MOTOR, DAMPER
(PULLEY)
(MOTOR)
(DAMPER)
Open the lower cover cap ( ¥L )
by using coin.Turn the drain plug
( ¥M) to pull out the hose.
Unplug the drain plug ( ¥M) , then
the water flows out,
At this time use a vessel
to prevent water flowing on the
floor. If the water does not flow any
more,turn the pump filter ( ¥N)
open to the left.
Take out any foreign material
from the pump filter ( ¥N). After
cleaning, turn the pump filter(¥N)
clockwise and insert the
drain plug ( ¥M)to the original
place. close the lower cover cap.
§
§
Clean the drain pump filter
To Next Page
Loading...