29
¤ Remove pump outlet hose.
¤ŁRemove tub pump bellows.
¤ØRemove cap(Remaining Hose.)
¤ŒDisconnect the wiring.
¤ºUnscrew 3 screws
¤ Remove the pump.
¤ Unscrew 3 screws fixing the heater protecting cover.
¤ŁLoosen the M6 heater nut to pull out the heater.
When mounting the heater, be sure to insert the heater
into the heater clip on the bottom of the tub.
¤ Pull it out by holding the thermistor bracket.
ƒTIf it is pulled by the wire, it may be broken.
¤ŁWhen mounting the thermistor again, make sure that it
is got back tight to the rubber.
PUMP
HEATER
THERMISTOR
CAUTION
To Next Page
Loading...