-54
■
ERROR MESSAGE AND CHECKING METHODS
2) WF-402
ERROR DECISION CAUSE FOR ERROR
BASIS OCCURRENCE
REMEDYERROR
• Water level does not
rise to the set level
in 40 minutes.
• Wash and rinse
LED blink.
• Water is not
completely drained
in 10 minutes.
• Rinse and spin
LED blink.
• Laundry unbalance
during spin.
• Wash, Rinse and
Spin LED blink.
• In the second QC
Mode the following
message is displayed.
• All of process LED
blinks.
WATER
SUPPLY
& INLET
V/V.
DRAINAGE
UNBALANCE
OVER
FLOODING
ERROR
• Water faucet is closed?
• Water supply is interrupted.
• Inlet V/V is clogged with dirts.
• Connector has bad contact to
the inlet valve.
• Yellow(YL) 2 pin connector has
bad contact to the P.W.B ASM.
• Is the drain hose located
properly?
• Drain hose is not lowered.
• Drain hose is folded or clogged
due to freeze or dirts.
• Bad Drain Motor part or
GRAY(GY) 2 pin connector to
the P.W.B ASM has bad
connection.
• Laundry in the INNER TUB is
filled unevenly.
• Washer is tilted.
• Is the CONNECTOR of Ball
pressure senor disconnected or
badly touched?
• Check INLET valve
• Open water faucet.
• Wait until water supply is
resumed.
• Clean or replace filter.
• Correct the connector contact.
• Same as above.
• Hung up drain hose at 0.9~1.3m
high. (For pump)
• Put the hose lower.
(For : Non-pump)
• Unclog the drain hose.
• Replace Drain Motor or correct
the connector contact.
• Try to fill laundry uniformly in the
inner tub.
• Adjust the leg.
• Check B.P SENSOR
CONNECTOR or replace B.P
sensor
To Next Page
Loading...
