What does WATER INLET ERROR mean on my LG WM2277H?
A WATER INLET ERROR on your LG washer means that the correct water level isn't reached within 8 minutes after water is supplied, or it doesn't reach the preset water level within 25 minutes.
What to do if my LG WM2277H Washer is leaking water, has excessive suds, fills slowly, or drains slowly?
If you're experiencing water leaks, excessive suds, slow filling, or slow draining with your LG washer, check and tighten the hose connections. Unclog the drain pipe, contacting a plumber if needed. Reduce your detergent amount or switch to a low-sudsing detergent. Ensure the water tap is fully open and check for water flow at another tap in the house. Straighten any kinks in the hose and inspect the inlet hose filter. Finally, clean both the drain hose and the drain filter.
What to do if the door on my LG Washer won't close or open?
Ensure the door is completely closed. If it still won't release, call for service.
What to do if my LG Washer experienced a power failure?
If your LG washer experienced a power failure, simply restart the cycle.
What does a DRAIN ERROR mean on my LG WM2277H?
A DRAIN ERROR on your LG washer means that the water hasn't fully drained within 10 minutes.
What to do if my LG WM2277H Washer load is too small or out of balance?
If your LG washer load is too small or out of balance, add one or two similar items to help balance the load. Rearrange the load to allow for proper spinning.
What does EEPROM ERROR mean on my LG Washer?
An EEPROM ERROR on your LG Washer means that the EEPROM is out of order.
What causes an OVER CURRENT ERROR on my LG WM2277H Washer?
An OVER CURRENT ERROR on your LG Washer can be caused by a faulty MAIN PWB ASSEMBLY or a short-circuited winding in the STATOR ASSEMBLY.
What causes a LOCKED MOTOR ERROR on an LG WM2277H?
A LOCKED MOTOR ERROR on your LG Washer can be caused by several issues: * The MOTOR HARNESS connector is not connected to the STATOR ASSEMBLY connector. * Poor electrical contact between the MOTOR HARNESS and the MAIN PWB ASSEMBLY connectors. * A cut in the MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY. * A defective hall sensor.
Why does my LG WM2277H show an IMBALANCE ERROR?
An imbalance error on your LG washer can occur if the load is too small, the appliance is tilted, laundry is gathered to one side, or non-distributable items are in the drum.
Key safety instructions to minimize risks of fire, electric shock, and injury.
Guidelines for proper grounding to reduce the risk of electric shock.
Instructions for removing shipping bolts to prevent transport damage and ensure proper operation.
Guidelines for safe electrical connection and water supply hose installation.
Procedures for correctly installing the drain hose to prevent leaks and flooding.
General| Type | Front Load Washer |
|---|---|
| Energy Star | Yes |
| Color | White |
| Steam Washer | Yes |
| Voltage | 120V |
| Control Type | Electronic |
| Water Level Options | Automatic |
| Spin Speed | 1200 RPM |
| Height | 38 3/4" |
To Next Page
