27
USING YOUR WASHING MACHINE
ENGLISH
Saving Energy, ColdWash
™
Adding the ColdWash™ option reduces energy usage and
provides the same washing performance as a warm water
wash.
By using six different washing motions (Tumbling, Rolling,
Stepping, Scrubbing, Swinging, and Filtration), fabrics get the
cleaning benefits, without the energy usage.
1
Press
A
and turn
B
to select the desired cycle.
2
Press . The washer will automatically adjust
the cycle
settings.
3
Set any other desired options.
4
Press
C
.
NOTE
y
When you select the ColdWash™ option, wash time
will be increased up to 10 minutes.
y
For high wash efficiency, we recommend using ColdWash™
with less than 8 pounds of laundry.
Turning On/Off Melody and Button Tones,
Signal On/Off
The washing machine plays a melody when the wash cycle
is finished. The buttons make a sound each time a button is
pressed. You can turn the melody and button tones on and
off with the Signal function.
To Set Signal to OFF
Press and hold for 3 seconds during the wash
cycle.
- Once Signal OFF is set, you will hear a beep.
To Set Signal to ON
(When the-end-of-cycle signal is disabled)
Press and hold for 3 seconds during the wash
cycle.
- Once Signal ON is set, you will hear a beep.
Setting Options During Cycle
You can add the following options during the wash cycle.
Button Lock Feature, Child Lock
Use this option to disable the controls and prevent children or
others from changing cycles or operating the machine. It can
also be useful for cleaning the button and control panel area.
Once the Child Lock has been set, it must be deactivated
before any controls, except the POWER button, can be used.
To Turn Child Lock ON
Press and hold for 3 seconds during the wash
cycle.
- When the Child Lock is enabled, a
N
message and the
remaining wash time are displayed, in turn, on the display
panel of the washing machine.
To Turn Child Lock OFF
(When the Child Lock is activated.)
Press and hold for 3 seconds during the wash
cycle.
NOTE
y
Child Lock lasts after the end of cycle. If you want to
deactivate this function, press and hold the Pre-Wash
button for 3 seconds.
Detecting weight of load, LOAD SIZE
Loading the washing machine and pressing the start button
triggers the machine to detect the weight of the load, and
displays the load size icon on the display panel for 10
seconds. If the load size icon is not on, you can check the
weight of the load again during the cycle. This feature
will help you set the detergent amount so as to wash clothes
efficiently based on the detected load size.
NOTE
y
If the washer has detected a small load size, the display
may only show one lighted bar. Only a small amount
of detergent should be used, because the amount of
clothing and the quantity of water that will be used is
small.
y
The load detection routine only works with dry clothes.
Since the detection system is detecting the WEIGHT of
the load, it will be affected by unusually heavy articles
in the load. For example, a garment that is already wet
that is loaded with other items will cause the LOAD
SIZE reading to be inaccurate.
To Next Page
Loading...
