9
ENGLISH
INSTALLATION INSTRUCTIONS
UNPACKING AND REMOVING SHIP-
PING MATERIAL
1. After removing the carton and shipping material,
lift the washer off the foam base. Make sure the
plastic tub support comes off with the base and is
not stuck to the bottom of the washer.
If you must lay the washer down to remove the base
packaging materials, always protect the side of the
washer and lay it carefully on its side. DO NOT lay
the washer on its front or back.
2. Save the foam block (that contains the Own-
er’s Manual, parts and laundry product sam-
ples) for future use. If the washer must be
moved in the future, this will help prevent
damage to the washer during transportation.
NOTE: To prevent damage, do not remove the
foam block until the washer is at the final location.
3. Unfasten the power cord from the back of the
washer.
TOOLS YOU WILL NEED
y Adjustable Pliers
y Carpenter's Level
Plastic Tub Support
Carton Base
To Next Page
Loading...
