38
EN
Symptoms Reason Solution
UE
UE rebalancing operation is
not successful.
• The automatic attempt to rebalance the load
was not successful. The cycle has been paused
to allow the load to be manually adjusted.
The load is too small.
• Add more items to allow the washing machine
to balance the loads.
Heavy articles are mixed with
lighter items.
• Wash articles of somewhat similar weight.
The load is out of balance.
• Manually redistribute the load if articles have
become tangled.
tE
Control error.
• Unplug the washing machine and wait 60
seconds. Reconnect power and try again. If the
error code is not released, call for service.
FE
Water level is too high due to
a faulty water valve.
• Close the water taps, unplug the washing
machine, and call for service.
PE
The water level sensor is not
working correctly.
• Close the water taps, unplug the washing
machine, and call for service.
LE
A motor error has occurred.
• Allow the washing machine to stand for 30
minutes and then restart the cycle. If the error
code is not released, call for service.
AE
Clutch error.
• Unplug the washing machine and call for
service.
tcL
Limpieza de Tina (Tub Clean)
Alarm.
• Run the Limpieza de Tina (Tub Clean)
programme.
E3
Sensor for cloth-sensing is
defective.
• Manually redistribute the load if articles have
become tangled.
Motor’s revolution is too low.
• Unplug the washing machine and wait 60
seconds. Reconnect power and try again.
• Call for service.
Contact-point of Connector is
defective.
CL
CL is not an error. This
prevents children from
changing cycles or operating
the appliance.
• To deactivate, press the Temp. (Temp.) and
Enjuague (Rinse) buttons simultaneously for
3 seconds.
To Next Page
Loading...
