SPECIFICATIONS/USING SMARTDIAGNO%S _ 35
SPECIFICATIONS
Model 1CW
Description Top--Loading Washer
Electrical requirements 120 VAC @ 60 Hz.
Max_ water pressure 14.5-116 PSI (100-800 kPa)
Dimensions 27"(W) X 283/S'(D} X 45"s/s"(H), 553ia'(H with lid open)
68.6 cm (W) X 72i cm (D) X ! 15_3 cm (H), 141.7 cm (H with lid open)
Net weight 145.5 Ibs. (66 kg)
Max. spin speed 1,100 RPM
USING SMARTDIAGNOSIS TM
- Onty use this feature when nstructed to do so by the call centen The transmission sounds simitar to a fax machine, and so has
no meaning except to the call center.
SMARTDIAGNOStS TM cannot be activated if the washer does not power up tf this happens, then Iroubleshooting must be done
without SMARTDIAGNOSIS TM
If you experience probterns with your washer, call 1--800-243-OOOO (1_888_542-2623 in Canada) r-___ltowthe calt center agent's
instructions, and perform the following steps when requested:
1. Press the _ to turn on the washer_ De not press any other buttons.
2. When instructed to de so by the ca!l center, place the mouthpiece of your phone very close to the POWER button.
3 Press and hold _-_._/for three seconds, while holding the phone mouthpiece to the icon or POWER button
4. Keep the phone in place until the tone transrnission has finished. This takes about 17 seconds, and the display wit count down
the tirne.
• For best results, de not r-nove the phone while the tones are being transmitted and de not touch the console wth the phone.
, If the cati center agent is not able to get an accurate record ng of the data, you r'nay be asked to try again.
- Pressing the POWER button during the transmission wiII shut off the SMARTDIAGNOSIS TM.
5. Once the countdown s over and the tones have stopped, resume your conversation with the call center agent, who witt then be
able to assist you using the information transmitted for analysis at the call center.
To Next Page
Loading...
