14 NSTALLAT_ON _NSTRUCTIONS
Connecting the water lines
Check the rubber seals on both sides of the hose,
o Insert a rubber seal into the threaded fittings on each
hose to prevent leaking.
Rubber seal
[__
Rubber seal
Water hose
(To water inlet on the
washing machine)
Water hose
(To tap)
4
Connect the hoses to the water inlets tightly by hand and
then tighten another 2/3 turn with pliers,
- Connect the blue hose to the cold water inlet and the
red hose to the hot water in_et,
water inl
Cold water inlet
2 Connect the water supply hoses to the HOT and COLD
water faucets tightly by hand and then tighten another
2/3 turn with pliers.
.-Connect the blue hose to a cold water faucet and the
red hose to a hot water faucet.
5 Check for leaks by turning on the faucets.
•-If water leaks, check steps 1 to 4 again,
NOTE ................................................................................................................................................................................................................................................................................
• Periodically check the hoses for cracks, leaks and wear,
and replace the hoses every 5 years.
° When moving or installing the machine do not stretch,
crush of kink the hoses,
• Water supply pressure must be between 14.5 PSI and
116 PSI (100-_800 kPa), If the water supply pressure is
more than 116 PSI, a pressure reducing valve must be
instafled,
° To provide optimum washing performance the hot
water temperature should be set at 120-135°F (48_57°C)
and the coJd at 60°F (15°C).
3
After connecting inlet hose to water faucets, turn on the
water faucets to flush out foreign substances (dirt, sand
or sawdust) in the water lines. Let water drain into a
bucket, and check the water temperature,
To Next Page
Loading...
