LG XD5B14PS - Final Installation Check

17
INSTALLATION
ENGLISH
Final Installation Check
Testing the Dishwasher
1 Turn on electrical power.
2 Turn on house water supply.
3 The door should open and close smoothly and
without harsh noises, if the unit has been
levelled correctly.
4 Run the appliance on a Rinse cycle to verify
proper operation and check for leaks.
Installation Check Error Codes
Error
Code
Possible Cause and Solution
OE
Drain hose kinked or pinched.
• Feed the drainage and supply
hoses through the hole under
the sink. Then gradually slide the
dishwasher into the cabinet
while pulling on the hoses under
the sink to take up any slack. This
helps avoid kinking the hoses or
trapping them beneath the
dishwasher.
Waste spigot under sink is
clogged.
• Drill out the waste spigot under
the sink.
IE
Water supply line kinked under
dishwasher.
• Feed the drainage and supply
hoses through the hole under
the sink. Then gradually slide the
dishwasher into the cabinet
while pulling on the hoses under
the sink to take up any slack. This
helps avoid kinking the hoses or
trapping them beneath the
dishwasher.
House water supply not turned
on.
• Turn water on. Water pressure
may be too high or too low.
Error
Code
Possible Cause and Solution