LGMG North America Inc. Operation and Safety Manual
5
9) Do not drive in high-speed descending any
slope.
10) Do not use the platform control station to
release the platform when the platform is
tilted, stuck, or its normal operation is
obstructed by other nearby obstacles.
Before using the ground control station to
release the platform, all personnel must exit
the platform.
11) Do not use the platform to push or pull
anything outside the platform.
12) Do not use the machine as a crane.
13) Do not place, fasten and fix or suspend
loads on any component of the machine.
14) Do not place ladders or scaffolds within the
platform or against any component of the
machine.
15) Do not attach platforms to adjacent
buildings.
16) Do not change or disable limit switch.
17) Do not tie platforms to adjacent
components.
18) Do not place loads outside the platform
guardrail.
19) Do not change or damage any component
that may affect the safety and stability of
the machine.
20) Do not replace key parts that affect
machine stability with parts of different
weights or specifications.
21) Do not change or modify the aerial work
platform or install additional equipment for
placing tools or other materials on platforms,
pedals or guardrails, which will increase
platform weight and surface area or load.
22) Do not push machines or other objects with
the platform.
23) Tools and materials, evenly distributed and
able to be safely moved by the operator in
the platform, can be carried in the platform
only.
24) Do not use the machine on a movable
surface or vehicle.
25) Keep all tires in good condition and
appropriately tighten the lug nuts.
26) Ambient temperature for machine operation
is -20℃-40℃.
27) The allowable fluctuation of machine power
supply voltage is ±10%.
1.8 Crushing Hazards
1) Do not place arms, hands, or fingers in any
position where there is a hazard of potential
crushing by the machine’s scissors.
2) Do not place your hands in a position
where you may get pinched when folding
the guardrail.
3) Grasp the platform guardrail all the time
when removing the pins fixed on the
guardrail. Do not let the platform guard rail
fall off.
4) When the machine is being driven from the
ground using the controller, use good
judgment and carefully plan the travel path.
Keep a safe distance between the operator,
machine and any fixed objects, walls, or
buildings.
1.9 Hazards When Operating
on a Slope
Do not drive the machine on a slope that
exceeds the slope and side slope rating of the
machine. The rated value of slope is applicable
to a stowed machine.
SR2669D(With outrigger)/SR3369D/SR4069D:
To Next Page
Loading...
Need help?
General
