Liberty Safe - S&G Electronic Locks Opening Instructions

Owner Use and Care Manual
S&G ELECTRONIC LOCKS-OPENING INSTRucnONS
A IF COMBINATION DOES NOT WORK, DO NOT CLOSE DOORI Try Again.
Refer to the TROUBLE SHOOTING GUIDE in the back of this manual for more help.
CHANGING COMBINA nONS ON MANUAL LOCKS
It is inadvisable for anyone other than a CERTIFIED LOCKSMITH to change the
combination on a manual lock. Changing the combination by anyone other than a
certified technician will void the lock portion of your warranty. Call your dealer or
Customer Service Representative (CSR) at Liberty Safe (800) 247·5625, press 4, for an
approved certified locksmith. '
A WARNING! All Electronic locks are set at the factory
to 123456 #. For security purposes, you should change this
combination to your own, new combination number. (See
instructions below)
.A Before entering your electronic lock combination, center the
handle between left and right stop points. If the handle or lock
mechanism is pressuring the lock, it may not open the lock.
A Before entering your electronic lock combination, remove any static charge you
may have by touching your finger to the body of the safe. Discharging static electricity
into the lock can damage it and prevent proper operation.
Enter your 6-digit combination followed by the pound (#) sign. When each number is
pressed, the lock will chirp and the red LED on the keypad will momentarily light up. After
pressing the # sign, you should hear a 'click' sound a few seconds after entering the
code indicating the lock has opened and it is okay to turn the handle and open the safe
door. You have 6 seconds in which to turn the handle. If you wait longer than 6 seconds,
the door will re-Iock and you will need to enter the code. If you experience any problems
opening your safe, refer to the Trouble Shooting section in this manual. If you pause
more than 10 seconds between each number the lock will reset itself. If you press an
incorrect button when entering the code, press the star (.) button and start. As a security
feature,4 incorrect codes will lock will stop working for a period of 15 minutes.
To lock your safe, close the door and tum the handle until it stops. You should hear a
'click' indicating the lock bolt has dropped into place. Check by trying to open the door.
After you have changed the combination on your electronic lock to your own unique
combination, please fill in this combination on your warranty card and return to Liberty
Safe. As part of our continuing service, a record of your combination by serial number is
kept on file at Liberty Safe. If you lose your combination it can be restored to you for a
Rev: 01.01.08
Page 4
P\04.9