19
English
7. CLEANING AND MAINTENANCE
7.1 Replacing the DC plug fuse
• Pull off the adapter sleeve from the DC plug.
• Unscrew the screw out of the upper half of the housing.
• Carefully raise the upper half of the housing from the lower half.
• Take out the contact pin.
• Replace the detective fuse with a new fuse with the same type and rating
• Re-assemble the plug in the reverse order.
7.2 Cleaning the cooling device
• Occasionally clean the device interior and exterior with a damp cloth.
• Make sure that the air inlet and outlet vents in the device are free of any dust and dirt,
so that heat can be released and the device is not damaged.
WARNING!
Always disconnect the device from the power supply before you clean and service it.
NOTICE! Risk of damage.
Never clean the cooler under running water or in sink.
Do not use abrasive cleaning agents or hard objects during cleaning as these can
damage the cooler
To Next Page
Loading...