Liebert HPC-S 022 - Page 40

Application Consideration
10 -- 4
Liebert HPC---S 006---022---PD---273571---01.03.2012
Fig. 10c --- Lifting instructions with tubes
SPLIT PIN
(NOT SUPPLIED)
BLOCKING PEG
(NOT SUPPLIED)
N.B: Place the lifting tubes in the holes marked “LIFT HERE” on the base and block the ends of the tubes with pegs and split pins as in
PART . “ A ”.
The capacity of the lifting equipmentmust be sufficient for the load to b e lifted. Check the unitweight, the load capacity of the balance,
the chords and the quality of the above mentioned apparatus.
BEL T OR CHORD
LIFTING TUBE (NOT SUPPLIED)
(BASE HOLES Ø45)
PROTECTION
PLANK
RIGID STRUTS
(POSSIBLY STEEL)
PART. ”A”
”A”
”C”
”B”
Tab . 10f --- Lifting
Models Fans number
“A”
(m)
“B”
(m)
“C”
(m)
CB0 / FB0 006 --- 007
CG0/FG0006
1
1,7
≈3
≈8
CB0 / FB0 009 --- 011 --- 014 --- 015
CG0 / FG0 007 --- 009 --- 011
2
≈4
CB0 / FB0 018 --- 019 --- 022
CG0 / FG0 014 --- 015 --- 018
3