2.5. Make the back of mop board face to the bottom of the robot vacuum, and press
the fixation down against the hole on the mop module, till hear the sound “ka” that
means install successfully. Gently flip the device over, place it on the floor and turn
on the power, short press “ ” or press the “ ” button to start the mopping
function.(When the mopping board is installed, the device will automatically be
in mopping mode afterit is turned on.) Please do not use the mopping function on
carpets.
Method Of Usage
YOJKVUIQKZY
HGIQ
.URKVUYOZOUTULZNKSUVSUJ[RK
ZUYZGXZ
1. Before using Robot, pick up objects like clothing, loose papers, pull
cords for blinds or curtains, power cords, and any fragile objects.
Please also set up protective facilities at the entrance of the stairs,
elevator entrance, kitchen and bathroom and other rooms to avoid
damage device.
Note: Do not use the robot to clean up standing water.
2、Use of mopping function
2.1. Press the dust box buckle and pull
the dust box, and remove the water
tank from device.
2.2. Please inject amounts of water to
the water tank, closing the water tank
cover tightly and install the device in
the opposite direction.
2.3. Install the water tank which is
injected with water to robot vacuum.
2.4. Take out a piece of mop, at first put
the raised part of the mop board into
the pocket of the mop, and then press
the mop onto the mop board to be
symmetrical with its outer contour.
METHOD OF USAGE METHOD OF USAGE
0807
To Next Page
Loading...
