*Please do not add detergent to the water tank and do not wash or soak the water tank.
1. Suction inlet cleaning(Once a week is recommended)
Gently turn the device over and wipe the suction port with a clean dry cloth.
2. Side brushes cleaning (Once a week is recommended)
3. Water tank, dust box and filter cleaning (Once a week is recommended)
* Please confirm the correct position corresponding to the left (L) and right (R) brush
installation.
* Side brushes are consumables, and it is recommended to replace them every 3 months
to ensure the cleaning effect.
* Please purchase on the official website
2.1. Gently turn the device over and
pull out the side brushes vertically.
2.2. Reinstall it after cleaning the
entanglement and dirt.
3.1. Press the water tank /dust box
buckle and pull out the water
tank /dust box.
Filter buckle Primary-filter HEPA Sponge
* HEPA filter and sponge are consumables, it is recommended to replace a set every
3 months, please buy it on the official website.
3.3. Remove the filter gauze, HEPA filter and sponge, wash the filter gauze with
water, and use cleaning tools to clean up the rubbish mixed in HEPA. HEPA
is not washable,sponges are washable. Then clean the dust box, wait for
the sponge and filter gauze to dry before putting it back for use.
3.4. Make sure there is water in the water tank before using the mopping function.
Press the button on the water tank/dust box and pull the water tank/dust box
back out. Open the water tank cover, inject amount of water and fasten the
water tank cover. Reinstall the 2-in-1 dust box in the opposite direction from
which it was removed.
3.2. Press the filter buckle and open
the filter cover to dump out the
trash in the dust box.
Maintaining
MAINTAINING MAINTAINING
1817
To Next Page
Loading...
