15
Setup Instructions
Setting up the SitnStand Compact is performed by the user.
The setting up process consists of three steps:
A. Charging the battery for the rst time.
B. Placing the SitnStand Compact on an appropriate seat.
C. Connecting the battery.
A – CHARGING THE BATTERY FOR THE FIRST TIME-FIGURE 2
Charge the battery for at least 12 hours before use:
1. Remove the battery from the box.
2.
Plug in the battery charger into an electric wall socket.
3.
Connect the battery charger connector to the battery
charging socket.
4. When the green light is on, battery is fully charged.
5. When red light is on, battery is not fully charged.
NOTE: To prevent falling over any tangled cable,
place the battery close to the charger.
User Manual | Using the Sitnstand
Figure 2
To Next Page
Loading...