16
Measurement
•
Using the Start/stop button , switch off the blood
pressure monitor. The measurement is then stored
in the selected user memory.
If you forget to turn off the device, it will switch off
automatically after approx. 1 minute. In this case too,
the value is stored in the selected or most recently
used user memory.
•
Wait at least 5 minutes before taking an-
other measurement!
NOTE:
This monitor will re-inflate automatically if the system de-
tects that your body requires more pressure for measure-
ment. As soon as a heart rate is detected, the heart rate
symbol is displayed.
•
When the measurement is completed the cuff will deflate
entirely. Heart rate, systolic and diastolic blood pressure
are displayed.
•
You can interrupt measurement at any time by pressing
the start/stop button .
•
_ appears if it has not been possible to perform the
measurement properly. Observe the section on error mes-
sages/troubleshooting and repeat the measurement.
•
The test result is saved automatically.
•
To switch off and release the pressure, press the start/
stop button again. If you forget to switch off the de-
vice, it switches off automatically after approx. 1 minute.
Wait at least 5 minutes before taking another measurement.
7. Evaluating results
WARNING:
•
This product does not and is not intended to provide a
medical diagnosis. Measurements results are for refer-
ence only. Self-diagnosis and treatment, e.g. regarding
medication, using measured results represent a risk for
your health. Always consult with a licensed physician
for determination of appropriate medication and dos-
age thereof. Follow the instructions of your physician
or licensed healthcare provider. If you have or suspect
that you have a medical problem, promptly consult your
physician. If you have an emergency please call 911
immediately.
•
Only a physician or a trained health care professional
who is familiar with your medical history is able to ac-
curately interpret your blood pressure measurements.
Consult your physician before starting blood pressure
monitoring.
•
Please note that technically related measuring toler-
ances are possible. Please see section “11. Technical
Specifications” for details.
To Next Page
Loading...