Use these products for their intended use as described in this manual. Do not use attachments that have not been
recommended by the manufacturer.
The product should never be left unattended when plugged in. Disconnect from the electrical outlet when not in use,
and before putting on or taking off parts.
Never operate the product with the air openings blocked. Keep air openings free of lint, hair, or any other obstructing
material.
Never operate the product if it has a damaged power cord or electrical plug, or if it has been dropped, damaged, or
even partially immersed in water. Contact Customer Support Services.
Allow LCD consoles to “normalize” with respect to temperature for one hour before plugging the unit in and using.
Health and Environmental Regulations Warning - This product may contain chemicals known to the State of California to
cause cancer, birth defects, or other reproductive harm. For more information related to the European Commission
Regulation (EC) No. 1907/2006 (REACH) and the California Safe Drinking Water and Toxic Enforcement Act of 1986
(Proposition 65), please visit https://www.lftechsupport.com/web/guest/environmental-regulations-information.
In conformity with the European Union Machinery Directive 2006/42/EC, this equipment unloaded runs at sound pressure
levels below 70 dB (A) at the average operating speed of 8 km/hr. Noise emission under load is higher than without load.
Installation
• Place on a stable, flat surface in a horizontal position during use for maximum stability.
• Check all belts, pulleys and bungee cords regularly for signs of wear, and replace if needed.
• Check regularly and follow all instructions for maintenance as specified in this manual.
• Replace immediately any defective parts and do not operate unit until all repairs are complete.
FCC Compliance Information
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment
under FCC rules.
Page 7 of 32
To Next Page
Loading...